2. Drill 1/8" pop-rivet holes for hook & loop bracket (WD-1V) in similar manner.

3. Install (WD-1) clips at top of diffuser and hook & loop brackets at bottom of diffuser with white headed pop-rivets. Insert pop-rivet from gel-coat side of diffuser.

4. Mount 6" wall Z-Bar (WB-6) to wall using appropriate fasteners to secure wall bar to wall structure. Top of wall bar should be located 1/8" below desired height of diffuser.

5. With WD-1 Bars and WD-1V Hook & Loop Brackets installed onto diffuser, peel off white back of hook & loop to expose adhesive, insert WD-1 Bars into wall Z-Bars with WD-1 bars fully engaged into wall Z-Bar. Press bottom of diffuser to wall to engage hook & loop adhesive. Level and adjust as necessary.

Note: Be sure to allow a 1" minimum clearance above top of wall bar to access WD-1 Clip onto wall bar.

*End of Section*